The Samducksa 300 Series of joysticks commonly utilize a rubber grommet, which acts similar to a spring in a joystick lever. It helps the shaft return to a neutral position after a direction is pressed and microswitch is engaged.
The ST-45 High Tension Rubber Grommet is designed for those who appreciate more force needed to engage the lever’s microswitch, plus a faster return to neutral.
MODEL AND PART GUIDE
The following reference list provides information of the battop, Silicone rubber, and bobbin style installed into each recent Crown model by the manufacturer. This is helpful if you are looking to purchase the correct grommet or bobbin for your chosen model.
|CWL-309MJ-KMS-ST25||CWL-BAT||Silicone Rubber ST25||CWL Bobbin|
|CWL-309 HelpmeK-KMS-ST35||CWL-BAT||Silicone Rubber ST35||CWL Bobbin|
|CWL-309FJ-KMS-ST35||CWL-BAT||Silicone Rubber ST35||CWL Bobbin|
|CWL-309MJ-BENYLIS-ST35||CWL-BAT||Silicone Rubber ST35||CWL DX Bobbin|
|CWL-309MJ-ST30 New Helpme||CWL-BAT||Silicone Rubber ST30||New Helpme Bobbin|
|CWL-303MJ-DX-ST35 Crazy Dongpal||CWL-DX-BAT||Silicone Rubber ST35||CWL DX Bobbin|
|CWL-309MJ-DX-QR-ST35||Samducksa Clear BATTOP||Silicone Rubber ST35||CWL DX Bobbin|
|Short SDL-301-DX||SDL-BAT||Silicone Rubber ST35||SDL Bobbin|
|SDL-301-DX-QR-ST35||Samducksa Clear BATTOP||Silicone Rubber ST35||SDL Bobbin|
If you intend to replace an existing grommet:
- First lift the battop and shaft from the joystick body. To do this, you must remove the e-clip at bottom of the lever. A mini screwdriver wedged into the e-clip often works, pulling the clip away from the shaft. Be careful not to lose the e-clip, as it can fly off the shaft from the pressure. Lift the shaft upwards and put aside. The actuator may also loosen from the microswitches which is normal – you can put it back on when reinstalling the e-clip.
- Second, remove the 4 long screws that hold the mounting plate and upper body in place. Remove the original grommet from its housing by pulling on the plastic ring with your thumb and fingers.